radial stress

Tapered pipe threads produce radial stress in female fittings.

锥管螺纹在内螺纹内会产生径向应力.

The elastic-plastic stress and displacement fields of cylindrically orthotropic composite thick-walled tube under uniform radial pressure are studied.

研究了在均匀径向压力作用下圆柱正交异性复合厚壁圆筒的弹-塑性应力场和位移场。

The main stress of a rotating composite flywheel rotor are hoop stress and radial stress theradialthe.

复合材料储能飞轮转子的内部主要应力是环向应力和径向应力.

Radial stress , axis stress and shear stress at the critical interface regions are obtained and compared.

对各情况下的轴向、径向和剪切应力做了比较分析.

In the vicinity of the borehole, the tangential stress is maximum and the radial stress in minimum.

得出在钻孔附近切向应力最大，径向应力最小。

The radial and tangential stress maximums are both in the inner surface of bearing alloy.

径向应力与周向应力的最大值位于轴瓦合金层内表面。

The force analysis of the drill string is carried out to obtain the calculation formulas of its axial stress, bending stress, torsion stress, radial stress, circumferential stress and additional shearing stress.

通过钻柱受力分析，给出钻柱轴向应力、弯曲应力、扭转应力、径向和周向应力，以及附加剪应力的计算公式。

When composite flywheel rotates in high speed, there will be greater radial stress and tangential stress because of internal force.

复合材料飞轮转子在高速旋转时，由于惯性力的作用，会产生较大的径向应力和环向应力。

Radial stress of combined curved beam and its influence on bending stress

组合曲梁的径向应力及其对正应力的影响

Both radiative compressional and shear wave energies from point volume, radial shear and tangential stress sources greatly increase with the raise of their frequencies.

随着频率的增高，点膨胀源、径向应力源和切向应力源的辐射纵波和横渡能量都有显著增加。

The thicker the kiln crust, the smaller the radial temperature grade of kiln wall, the lower the heat stress.

窑皮越厚，窑壁的径向温度梯度越小，热应力越低；

The effect of hydrothermal treatment on drying rate, ratio of tangential shrinkage to radial shrinkage and drying stress is discussed.

讨论了热湿处理与干燥速度、弦径向干缩比和干燥应力之间的关系。

Relatively, the different radial gradient of the elastic constants will have a great influence on the tangential stress and the radial displacement.

相对而言，弹性模量沿径向的不同梯度模型对环向正应力和径向位移的影响要大一些。

The changing features of shrinkage stress for Sugi ( Cryptomeria japonica D. Don) wood specimens were studied when dried with radial restraint using superheated steam at 120~ 180 ℃, and the effects of temperature and relative humidity on radial shrinkage stress were analyzed.

试验研究了日本柳杉在120～180℃高温高压过热蒸汽条件下，干燥过程中所伴随的收缩应力的发生发展特征，以及温度和相对湿度对径向收缩应力的影响。

Contact force generated by particles imposing on the surface of material can form contact shear stress and radial tensile stress.

材料表面受到颗粒冲击产生的接触压力形成接触剪应力，以及在接触边界上产生径向拉应力。